Elite EPC-807 Manuale di Manutenzione e Cura Scaricare il pdf (Pagina 3)

PARTS & FEATURES

1. Handle 9. Outer Pot 17. Bottom Handle

2. Lid 10. Upper Body & Handle 18. Electronic Heater

3. Pressure Limiting Valve 11. Control Panel 19. Seal Ring for Float Valve

4. Float Valve (external view) 12. Power Cable 20. Filter

5. Float Valve (internal view) 13. Steam Condensation Cup 21. Rubber Seal Ring

6. Lid Lock-Slider 14. Body Cover/Structure 22. Sensor

7. Sliding Latch for Lid 15. Spoon/Ladle Holder

8. Inner Pot 16. Lower Body Base

 During the process of removing the lid, please ensure that the height between the lid and the

upper edge of the cooker is always approximately 10cm. This is to ensure smooth

movement when turning and removing the lid.

BEFORE FIRST USE

Working

Pressure

PSI

Maximum

Pressure

Keep Warm

Temperature

Preset Timer

0~70kPa 12 PSI 90kPa 140ºF ~ 175 ºF 1~9 Hours

1. Remove packaging materials such as cardboard, plastics or Styrofoam and discard

appropriately.

2. Clean all the parts by wiping with a soft damp cloth or sponge and dry thoroughly.

LID ASSEMBLY:

1. How to open the lid: When the lid (2) of the cooker is at the Closed position (Figure 1), hold

the Handle (1) and turn it clockwise until you reach the Opened-Lid position (Figure 2). Lift

up and the lid will swing open vertically.

Note: For new units, the seal of the lid may be slightly stronger than normal and may be

slightly difficult to unlock. Once the lid has been opened and closed several times, it will loosen

up.

2. How to close the lid: When the Lid (2) of the cooker is in vertical position (Figure 4), hold the

Handle (1) and close it downwards at the Opened Lid position (Figure 5). Turn counter-

clockwise until you reach the Closed Lid position. (Figure 6).

3. How to dismantle the lid: When the lid (2) of the cooker is in the upright vertical position

(Figure 7), hold the lid with both hands, and adjust the height between the Lid and the upper

edge of the cooker to approximately 10cm (Figure 8). Then turn it counter-clockwise until you

reach the Closed Lid position (Figure 9). In order to remove the lid, you will need to move in an

upward direction (Figure 10).

1 2 3 4 5 6 7 8 ... 22 23

Nessun commento

Elite EPC-807 Manuale di Manutenzione e Cura Pagina 3